Electronic Project 4 DC Motor Driver Arduino Controller Board L293D Module Sheild For Arduino

Electronic Project 4 DC Motor Driver Module L293D Module Sheild For Arduino

Introductions

The drive module can directly drive four DC motors, drive the car chassis is 4WD 4 choice. Driving battery big up to 1A generally smart car motor current 100-300MA only four are sufficient to meet the control requirements. While leaving Road stepper motor interface can drive Road five line four-phase stepper motor or Road, two-phase four-wire stepper motor, very suitable for precise control requirements.

Specification

Driver chips: L293D dual H-bridge DC motor driver chip

Terminal of driven part supply range Vs: +5 V ~ +16 V
Take power from the plate Supply area Vs +6 V ~ +16 V
The peak current of driven part Io: 1A
Logical part of the operating current range 0 ~ 36mA
Signal input control voltage range IN1/2/3/4/5/6/7/8
Signal input enable voltage range EN1 EN2 EN3 EN4
Maximum power consumption 20W (temperature T = 75°C)
Board Size Size: 38mm * 91mm

Package Included:

1 pc 4 DC Motor Driver Module L293D Module Sheild

 

 

More product:

 

	UNO R3 + breadboard 400 point + 9V battery snap Starter Learning Kit		HC-06 Bluetooth Wireless Module
	Mega 2560 R3 ( CH340G )		HC-SR501 Human body Pyroelectric Infrared sensor PIR
	DC 5V Stepper Motor 28BYJ-48 + ULN2003 Driver Test Module		Ultrasonic Sensor HC-SR04
	LCD 1602 I2C module (Yellow Green light) ( Red board module)		20cm Male TO Female 40Pin Solderless Jumper Breadboard Wire

 

 

FAQ:

 

1. What is the delivery time?

Normally, 1-5 workdays after payment;

Special requirement orders, delivery time is negotiable.

 

2.If the products can’t work after receiving it,what should I do?

We will replace new items for you at once, and respect your final decision for wrong goods.

 

3.If the products don’t meet my demand after I received it,can I return it?

Yes,no problem.

You can return back to us, we will refund your full payment.